null
Created with Sketch. Created with Sketch.
Toggle menu
Phone 1300 400 888
1300 400 888
  • DTA Anti Slip Solution For Tiles

    • DTA Anti Slip Solution For Tiles

    $46.00 - $217.00

    or make 4 interest-free payments of $11.50 AUD fortnightly with Afterpay More info

    (No reviews yet) Write a Review
    Shipping:
    Calculated at Checkout

    Possible Delay (Contact Us)

    Product Description

    DTA Anti Slip Solution For Tiles

    DTA Anti Slip Solution is best used on ceramic glazed tiles, mosaic tiles, quarry tiles, terrazzo and unpainted/unsealed concrete. As it is designed to the etch the surface of the material and not not change the look, it MAY change the look of the surface in some circumstances.

     

    Application:

    1. Clean the surface with a normal floor cleaner to remove grease and grime. Rinse with clean water after initial clean.
    2. Always ensure you apply the Anti-Slip to a wet surface.
    3. 1 Litre of Anti-Slip treats UP TO 10 square metres in up to three applications. Spread the Anti-Slip evenly over the surface using a brush, natural bristle broom or sponge squeegee. It's recommended that the application be performed in small, manageable areas.
    4. IMPORTANT: NEVER allow the Anti-Slip solution to dry at any stage of the application. If the surface does start to dry, you MUST re-apply clean water to the surface area.
    5. The 1st application must be left for 2 - 3 minutes, depending on the temperature and humidity. It may have to be modified depending on the conditions. 
    6. Apply the Anti-Slip in a north to south, then east to west direction to ensure 100% coverage. Rinse thoroughly with clean water between each coat.
    7. For the 2nd application, re-apply and again allow to stand for a similar time, not allowing the product to dry.
    8. Repeat for 3rd application.
    9. Wash excess product from surface with floor detergent.
    10. Rinse with clean water; A second rinse with clean water is recommended to remove all remaining product.
    11. IMPORTANT:  Failure to remove product may result in a white haze appearing on the tiles as product continues t dry.
    12. Finish with a damp mop or vacuum dry.
    13. Floor is safe to walk on immediately after application is complete.

    **PLEASE NOTE**: FAILURE TO PROPERLY FOLLOW DIRECTIONS FOR USE MAY NOT END WITH DESIRED RESULTS.

    Product Videos

    Custom Field

    Product Reviews

    Write a Review

    You May Also Like...